techt zero kick problems

I installed the techt zero kick and rufus dawg wicked bolt in my alpha black. has anyone else noticed problems with the spring being too stiff? seems like it doesn't have enough pressure sometimes to cock the marker and it makes that noise we all hear when you are out of air. although it's not. anyone seen this or know what the problem is? I ordered some springs with varying strengths but have not taken the time to try one out.

There in lies the problem with the zero kick hammer. They aren't compatible with tons of other upgrades. By the time you get the springs right, you will be right back with the same amount of kick you had before you got it.

Your best option is to loose the ZKHammer. It's one of the only things from TechT that isn't top notch.

I was going to say that it was the bolt, I haven't had any problems like that with the rufus dawg bolt and powertube. Did you get it fixed?

im betting if you add some sort of shim ( like a small dowel pin or something similiar) at the end of the butt stock where the rear spring goes into that may solve it

Tech t also makes a weight for the hammer. I installed that n mine works great i have the same setup RD bout and power tube.
http://www.rockstartactical.com/TechT_Paintball_Zero_Kick_Hammer_Weight_Kit_p/tech-ham-wk.htmcheck it out its make for that problem

ya the original was too light
thats the issue with that zero kick bolt

every one I see that has an issue has had that bolt
I personally dont like it since i see the problem too many times

but paintball junkie is correct they add the weight to
and it might be better