Larry is back!

Hey it's Larry and I created a new account becasue my last one wasn't working. Anyway I'll have a picture and a list of what I have on my AB soon.

welcome back...nice job on the Alpha

WB Bro

Welcome back and she looks really pretty

thats a sick looking marker
good work man!


welcome back

Very nice marker set up and welcome back

Welcome aboard mate and very tasty AB.
Slick paintjob too.
Love the silencer on the TPX too.....looks bada$$ 8)
Have some "reppage" :)

Welcome back! And she looks great dude! Love the two-tone, very clean as well.

Okay as I promised I will make a list of upgrades, mods, and future upgrades for the AB and TPX:
Alpha Black:
RAP4 16 inch raptor barrel
RAP4 mid length RIS shroud
RAP4 M16 front sight
RAP4 folding fore grip
RAP4 Cyclone upgrade kit
BT APEX2
BT Bi-pod
Rufus Dawg wicked bolt
Tippmann Cyclone with X7 low profile hopper
Tippmann US Army E Grip
Clos2727 flat top mod
Clos2727 forward assist side plate mod
Clos2727 T charging handle
Trijicon ACOG
3 point sling (not shown)
Modified gas line (not shown, will update with new photo soon)

Future AB upgrades:
Advanced Paintball Electronics (APE) Board

TPX:
RAP4 10 inch spec ops barrel and suppressor
MRT Pro series bolt
TPX Remote coil upgrade (not shown)
Lapco front block

Future TPX Upgrades:
High performance spring kit

Any recommendations as to what else I should do to modify or upgrade either of these?

polish the internals?

StormShadowz wrote:

polish the internals?

I had done that and forgot to make mention of it as well as the pen spring mod for the trigger pull

i guess the next step is mag fed :)

those plates on the side of your handguard were did you get them?

@StormSahdowz I'd love to do a mag fed conversion but the problem is I moded the internals too much to be able to do the mag kit and I'd need to buy a new tac vest for clip puches becasue the one I have now is not MOLLE gear.

@Red Panda I found the one you see on the Alpha Black off of ebay because at th time it was the cheapest place to find that part in metal. I searched "Metal Air Soft M16 Upper Reciever" and I had to look a bit to find a metal reciever for my top rail, t handle, and side plate. In order to attach the side plate you simply cut to shape (in toher words make sure if you have a cyclone make sure you can undo the bajo fitting and the hose can reach the cyclone) and then JB Weld it on (JB is a cold weld that sets in 24 hours and you can find it at a harware store for about $10). I'll try finding Clos2727's how to thread and post it up here for you. But if you meant the RIS rail covers on the front end of the gun, I just goggled RIS Rail Covers, picked the cheapest ones and painted over them

http://alphablackforum.com/forums/viewtopic.php?f=41&t=3530
This the tutorial
i followed for the T handle, flat top mod, and forward assist mod