HomePortalCalendarFAQSearchMemberlistUsergroupsRegisterLog in

Share | 
 

 How to Multicam/woodland Tiger stripe paint your gun

Go down 
AuthorMessage
project salvo pro
Pump
Pump
avatar

Posts : 272
Join date : 2012-04-06
Age : 21

PostSubject: How to Multicam/woodland Tiger stripe paint your gun   Wed Apr 11, 2012 12:39 am

Before I start telling you how to do this I will first say don't be scared to paint and read the whole how-to before you start. If you don't like the results you can always just paint it black again.

Ok, here we go...

1: Prep the marker by cleaning it properly and removing the internals.

2: Hang your gun in a well ventilated area.

3: Take your parts that get a lot of contact and place them on some news paper and paint them with the color that you want to see the most of in the end. For me these things were silencer, magazine, side rails, and charging handles. On an AB or Salvo the things I would do like this are the pistol grips, magazine, and anything that may be attached to the rails.


4: Take one of the colors that you want the stripes to be and hold the spray can at about two feet from the gun and coat it in the color. My first color was OD Green but I didn't get any pics of it.

5: Now is where your going to create the stripes out of blue painters tape. Rip one side of the tapes straight edge off making it more natural*.

Now rip off the other side creating your stripe.

Make some different with holes or ending it two parts on one end.


6: After waiting for the last coat of paint start applying the tape stripes to the body of the marker.
When you place the stripes place them like /////// rather than //-/[[-//.*
For this coat of paint I decided that the green was to light so I stood about four feet with the black paint and unevenly dusted the marker.

And remember the top an bottom of the gun.

Also bridge gaps like the holes on shrouds. I went across the spot that my cyclone goes through the shell.

If you think a stripe is two long rip it into two and separate them slightly.

Don't forget parts! Razz

Keep lines flush with marker parts*(I love weaving stripes through rails).

7: Repeat step 4 with another color.


8: Repeat steps 4, 5, 6 ,and 7 until you have a desired amount of colors*.

9: Wait for the last coat of pain to dry and cover it in a matte* sealer to make it last longer.

10: Results http://alphablack.forumotion.com/t142-a5-p90-paintjob#1167

*Remember that the whole point of the camo is to break up the unnatural look of the marker. Nothing in nature is perfect so some things need to be different.*
Back to top Go down
View user profile
David199619
Spec Ops
Spec Ops
avatar

Posts : 2290
Join date : 2012-04-06
Age : 22
Location : East Bangor, PA.

PostSubject: Re: How to Multicam/woodland Tiger stripe paint your gun   Wed Apr 11, 2012 12:40 am

Nice tut
Back to top Go down
View user profile http://myalphablack.weebly.com/index.html
 
How to Multicam/woodland Tiger stripe paint your gun
Back to top 
Page 1 of 1
 Similar topics
-
» Captain Atom DCUC Has a Bad Paint Job... How can I fix it?
» Chess Tiger for Ipad and iphone
» Which paint to use on vintage MOTU?
» Chess Tiger 2010 now 100% FREE!!!
» Conan figures from NECA

Permissions in this forum:You cannot reply to topics in this forum
Alpha Black Paintball :: The Chop Shop :: How To Guides-
Jump to: